The first batch of the mats have been in full use since March 2015 and they've had lots of use, especially by those of us who have been bagging the biggies in the last few months, as you'll have noticed from the pics on our Facebook Group and in TR. And in case you ask, there have been no complaints and no improvement suggestions so it seems we have the perfect yakking product.
An overview. Note the "Yeehah!" zone from 130cm to 160cm. |
Zoomed in to the first 70cm of the design. See how the 1cm gradations go close to the edge? |
A nice snapper nosed onto the nose plate. |
This mat will lie patiently and flat on the beach awaiting your fish. No more holding the corners down or piling sand on the corners to stop the mat doing the old auto-rollup trick. The material is tough but limp.
This mat has been designed by the Noosa Yakkers team for yak fishers. It's easy to clean, stow, wash, and is virtually guaranteed to attract fish holders as soon as you roll it out on the beach. Just take care you don't get trampled as they rush with cameras in hand to get a look at it.
What does it look like with fish on? Bloody fantastic.
Tunny's really nice PB Spaniard measured on the mat. Will you have a big enough mat when you finally get that biggie? |
A couple of other examples:
Two snapper in tandem. |
Even works upside down! |
The cost? Only about $30 (dependent on the AUD/Yuan conversion rate at the time of ordering).
And for only another ~$5 you can grab a 20x25cm Noosa Yakkers-designed waterproof Limits Table detailing the limit rules for all relevant Noosa area fish. The Limits Table is made from the same durable vinyl material as the Brag Mat and has a brass eyelet in one corner for securing almost anywhere in your kayak. These have also sold well and have all but stopped the radio enquiries we used to get while on the water like "What's the bag limit on grinners?".
The initial order of brag mats in December 2014 was well received. If demand continues, we’ll order more each year but we need a minimum number of ten per order. Like one? Just email the Group or post on our Facebook Group and a committee member will contact you.